山東干燥機常見的清洗辦法有哪些？

干燥機正常運轉后，應定時查看各體系的運轉狀況，并記錄工藝參數(shù)。一 天完畢時，應先封閉加熱設備，用水替代液體沖刷物料的剩下液體，然后封閉物料泵。當進口溫度降至100度以下后，可中止風機和排風機的運轉。

After the dryer is in normal operation, check the operation status of each system regularly and record the process parameters. At the end of the day, the heating equipment should be closed first, and then the material pump should be closed. When the inlet temperature drops below 100 ℃, the fan and exhaust fan can be stopped.

然后清洗干燥塔和除塵器，封閉除塵器和空氣錘，封閉總電源，完結出產(chǎn)操作，緊迫狀況下，設備有必要當即封閉，鼓風機和物料泵應首要封閉。假如遇到電源毛病，應自然然冷卻，然后翻開排污閥，排空泥漿管道，清洗設備。

Then clean the drying tower and dust remover, close the dust remover and air hammer, close the main power supply, and complete the production operation. Under the urgent situation, it is necessary to close the equipment immediately, and the blower and material pump should be closed first. In case of power failure, it should be cooled naturally, then turn on the drain valve, drain the mud pipeline, and clean the equipment.

別的，運用完畢后，應將噴淋盤取出，浸入水中，清洗剩下水。洗不潔凈的時候用刷子擦拭。由于噴霧盤上的殘留物會形成噴霧不平衡，嚴重影響噴頭的運用壽命，乃至損壞其他機件。因而,應，該有一個固定的結構。注意：為了保證干燥塔體及其管道及與制品接觸的部件都要清潔。

In addition, after using, the spray tray should be taken out, immersed in water, and the remaining water should be cleaned. Wipe with a brush when it is not clean. Because the residue on the spray tray will cause spray imbalance, it will seriously affect the service life of the sprinkler and even damage other parts. Therefore, there should be a fixed structure. Attention: in order to ensure that the drying tower body and its pipes and parts contacting with products are clean.